9/11 - Ground Zero Molten Metal Confirmed

[shure]

9/11 - Ground Zero Molten Metal Confirmed

YouTube - Broadcast Yourself.


more here:

http://s1.zetaboards.com/pumpitout/topic/3377263/

[stannrodd]

Watched it .. enclosed oxygen deprived .. but simply/minimally ventilated .. can do this.

The easy way to boost your fireplace is to let in a stream of air..

The bellows of a furnace do this too .. collapsing debris with fire is a compression condition .. deprive to induce .. the deprived fire will use any available source to remain active. Thermal induction will assist this process.

The ground zero melted blobites can be seriously looked at .. that would be good forensically .. don't ya think ?

Stann

[apollo_gnomon]

Drywall is made of gypsum. Gysum is CaSO4. In long-term oxygen-starved combustion gypsum can degrade to Ca and S02, with O2 pulled off by combusting carbon.

Reducing atmosphere - Wikipedia, the free encyclopedia

[kahn2010]

Drywall is made of gypsum. Gysum is CaSO4. In long-term oxygen-starved combustion gypsum can degrade to Ca and S02, with O2 pulled off by combusting carbon.

http://en.wikipedia.org/wiki/Reducing_atmosphere

Well how do you explain the melted metal in the BASEMENT, over 70 floors below the impacts?

Botyh towers had metal struts cut at exactly 45 degrees, and tonnes of molten metal in the basement that was still over 1500 degrees C 3 days later.

Explain that

[apollo_gnomon]

Botyh towers had metal struts cut at exactly 45 degrees,
I'll take this part first.

1 -That's demolition by cutting torch during the clean-up process. If you look closely you can see that the cut starts and stops. The quality of the cut shows clearly that it was made by a cutting torch barely large enough to cut the thickness of steel used for that part of the building. In some cases you can see that the worker had to reposition themself between the beginning and end of the cut. The angles of the cut reveal the position of the welder.

2 - If the columns (not struts, please educate yourself and use terms correctly - it might make your argument more plausable) were at the locations frequently shown in photos purporting to provide proof of this (please link to your faves, I'm not going to hand it to you) the entire building would have dropped to initiate collapse. Collapse initiated just below the floors where the impact and fires were located. No footage shows the entire building dropping by several feet followed by the top-down collapse.

[noewhan]

9/11 Incontrovertible Proof the Government is Lying

9/11 Incontrovertible Proof the Government is Lying - YouTube

[ultima1]

Please explain the molten metal under all the following buildings?

WTC 1
WTC 2
WTC 6
WTC 7

[eyeballkid88]

How can you work for these cunts Ultima....

How can you sleep at night being even remotely assocaited with these guys....

and remmerb these are the same people that at telling you who are the "bad guys"


(shakes head)

[eyeballkid88]

Please explain the molten metal under all the following buildings?

WTC 1
WTC 2
WTC 6
WTC 7

Do your own research, aparently youve done more than forum put together havnt you?

How come theres such a big gap here??

[ultima1]

Do your own research, aparently youve done more than forum put together havnt you?

I am asking a question, can you answer it or not? If not then do not bother posting BS.

[camreeno]

I suggest you guys watch "9/11: Blueprint for Truth" if you haven't already. It puts a lot of emphasis on the physically inconsistencies of the tower collapses and building 7.

http://video.google.com/videoplay?docid=-8182697765360042032#